Bests & Worsts Reviews from Amazon

Here is my review/suggestions.... I am a composer/musician/artist/mosaicist and work from home - basically a work-station for each discipline. Purchased two of these to clear up space in my livingroom. 27$ - so I purchased two. This is NOT a product to be all gung-ho in assembling. Make some tea/coffee/other beverage, relax, put on some music, and enjoy the journey of assembly, while getting to know the new addition to your flat. Things to consider - 1 - Not Tiffany quality, but if put together with some extra love, it will last awhile. 2 - Gorilla Glue, wood glue version. This is optional, but recommended. GLUE EVERYTHING! From the screws to the joints NOTE - this will render your product moot for return and disassembly. But, it will be sturdier to some degree since this is particle board. 3 - Cats. If you have them, either put them away while you assemble or accept that they will want to 'help'. Be aware there are tiny things they might eat or play with and lose, and it comes with styrofoam (which I don't understand why they still use - it's just harmful to everything) 4 - Surfaces. This scratches easily and I have cement floors. Put a towel down or do this on carpet to avoid scratches. Make sure whatever you decide, it's as level/flat as possible. 5 - Power Drill. Be seriously carefull with this. Use one, yes, but short, light, bursts, as this is particle board and will rip apart easily. 6 - Cleaning. Soft towel and Windex or other light cleaner works well. Don't be aggressive as it scratches easily. The instructions are... ok. Do a mock run before final assembly, especially if you opt to use glue. When gluing joints and whatnot, have a heavy object near to place on top while you allow the glue to dry a bit before continuing. The pieces are marked with LETTERS in RED, however, kind of hard to read. But at least they are there. Also which direction they go can also be kind of vague. Some of the diagrams are not accurate. I have included a photo one. The LARGER rods go on the btm and the SMALLER ones on top. The TOP caps you kind of have to just keep turning, even when flat to the shelf, until it can't turn any further. If you opt to use glue - wait a few hours before using it to make sure the glue has dried/sealed. This desk can ONLY be assembled in one direction - shelves only on the one side. I purchased two and am just going to turn the other one around - or you can be reckless and free and drill new holes, going against the conformity of the directions. You Go Rockstar! (You will run the risk of destroying your new desk). It's shallow - as in from what is deemed the front to the back. 15.5". Enough for a monitor and keyboard (there is NO keyboard pull-out shelf). But not much else. All depending on the size of keyboard/monitor you have. A standard/typical desktop hard drive will fit on the lower shelf. And JUST that - depending on its weight. Again - particle board, not quite that strong. Portable hard drives and what not are perfect for the upper shelf. Photos, nicknacks, and whatnot are perfect for the top shelf - however, if you have cats, they will just be invitations to knock off. Fair warning. This desk is OPEN - as in there are NO extra holes for cords. Again, you can drill new ones yourself but you run the risk of destroying your desk. It's compact - very compact. It can fit most places in a flat - like a tiny car can fit in random/odd spaces. But pretty much just a computer/laptop station. This is NOT a desk for someone who likes to spread out while they work - hence, I purchased two. There ya go, these are just my thoughts/suggestions. It's a good desk. It works. Don't be rough with it, and it will last. Go Forth and Create!