Bests & Worsts Reviews from Amazon

Frigidaire apparently has used this with differnt models. I was hesitant to buy because I couldn't find the exact model or part #. It isn't the original model I got (see pics) but is the same manufacturer and works great (green tag is old, red is new). Ours broke like 3 months after Fridgidaire warranty expired. I've added some pics that will hopefully help someone (click found helpful review if it did so it'll help more- I struggled finding help in the questions/reviews and kind of went out on limb buying). I've attached pics so you can compare to yours. You remove the old thru screws (mine were flathead) behind the front above where ice is made. Keep them because this model doesn't include new ones. Once you remove the old one you can hang (and connect cord at same time) the screws (2) back up- from the picture you can see it hangs- hang them a little loose so you can slide down and secure. Then tighten the screws. When doing that you have to make sure the back water "slide"- where the water flows in- is above the back part into the square in the back (see pic). And you're done. The front cap with on/off comes off easy and the screw will adjust the water level. Let it run a few cycles before adjusting- it took a few for mine to become regular. I thought it was low after one-two and adjusted and almost had a flood. If this looks like your ice maker it probably is! And much cheaper than getting someone to look at it plus parts- plus a pretty simple fix. Hope this helps some one I tried to post a lot of pics because there wasn't many out there.